My Crossword Maker Logo
Powered by BrightSprout
Save Status:
or to save your progress. The page will not refresh.
Controls:
SPACEBAR SWITCHES TYPING DIRECTION
Answer Key:
Edit a Copy:
Make Your Own:
Crucigrama Sopa de Letras Hoja de Trabajo
Calificar este Puzzle:
Log in or sign up to rate this puzzle.

Module 1 Trade Terms

Horizontales
The horizontal timber that forms the transition between the foundation and the frame is called the ____.
The lowest horizontal member of a wall frame or partition, which rests on the subfloor, is called the ____.
The amount of time a structure can withstand fire conditions is represented by a(n) ____.
A sloping structural member of a roof frame used to attach sheathing is called a(n) ____.
Lumber within a range of 2" to 5" thick and up to 12" wide is classified as ____.
A 1 x 4 nailed to ceiling joists to prevent twisting is the ____.
The equally spaced framing members that support floors and ceilings are called ____.
The chalky rock that serves as the basic ingredient in drywall is ____.
Material used to plug holes through the soleplate and top plate and prevent the passage of smoke or fire is called ____.
Cutting across the grain of lumber is called ____.
The diagonal members installed between joists to provide extra support are called ____.
A framed structure that projects out from a sloped roof is a(n) ____.
The organization that rates plywood is the ____.
The vertical framing member that forms the sides of a rough opening for a window or door is a(n) ____.
Panels made from layers of wood strands bonded together are known as ____ (initials).
The covering layer of material, such as brick, used as a facing material for a wall is called ____.
Lumber with edges that are shaped to overlap adjoining pieces is called ____.
Verticales
A triangular wall enclosed by the sloping ends of a ridged roof is a(n) ____.
Panels or boards laid directly on and fastened to the tops of floor joists are known as ____.
The sheet material or boards used to close in walls and roofs is known as ____.
An L-shaped lumber arrangement used to reinforce ceiling joists is a(n) ____.
Cutting with the grain of the lumber is called ____/
An engineered assembly that is used in place of stick-built joists and rafters to support floors and roofs is a(n) ____.
The uppermost horizontal framing member in a wall or partition frame is the ____.
When steel rods are installed in concrete, it is known as ____.
A short framing stud installed between the header and top plate or between the sill and soleplate is known as a(n) ____.
A length of lumber that is laid horizontally over the top plate of a wall is known as a(n) ____.
The material that is installed on top of the subfloor is the ____.
Strips of wood or metal applied to a wall to make it level, form an air space, or provide a fastening surface are called ____.
Plaster used to coat exterior walls is known as ____.
Pieces of lumber or fire-resistant material installed between studs to reduce airflow and stop the passage of fire are called ____.
The horizontal member that supports the load over a window or door opening is the ____.
The main support beam for a structure is the ____.
A device that instantly de-energizes an electrical circuit in the event of a ground fault is a(n) ____.