My Crossword Maker Logo
Powered by BrightSprout
Save Status:
or to save your progress. The page will not refresh.
Controls:
SPACEBAR SWITCHES TYPING DIRECTION
Answer Key:
Edit a Copy:
Make Your Own:
Crucigrama Sopa de Letras Hoja de Trabajo
Calificar este Puzzle:
Log in or sign up to rate this puzzle.

Module 3 Trade Terms

Horizontales
The Chemical process inside a battery that causes large crystals of lead sulfate to form on the plates instead of desirable minute crystals is called ____.
When a conductor connects all non-interruptible, noncurrent-carrying components of an installation to the chassis or frame of an appliance or unitary piece, it is called ____.
When one conductor of a two conductor system is connected to ground, it is referred to as ____.
The initial stage of three-stage battery charging, where the maximum amount of current is delivered to the battery until it reaches 80 to 90 percent of it's charge capacity is the ____.
An agreement that specifies the terms and conditions of power buying and selling between the utility and the PV system owner or operator and outlines the technical requirements of the PV system connection interface is called the ____.
The number of days that a solar PV system can continue to meet an electrical load requirement without additional input from the solar array is called its days of ____.
An application -specific junction box in which multiple solar panels are connected together to combine their output before being routed to the charge controller or inverter is the ____.
Verticales
An agreement that specifies the terms and conditions of power buying and selling between the utility and the PV system owner or operator and outlines the technical requirements of the PV system connection interface is called the ____.
The style of battery charge controller that diverts PV array capacity to another DC load whenever the battery charging process is inactive is called a(n) ____.
The recommended lowest level of battery discharge, measured in volts and specified by the manufacturer for a given battery type and construction, which is used as a control setpoint to disconnect the battery from the load to prevent its permanent damages is called the ____ (initials).
Often referred to as being at trickle charge or maintenance charge, the third stage of three-stage battery charging, where charging voltage is reduced to maintain the fully charged condition of he battery is the ____.
The voltage setpoint at which a battery charge controller perceives roughly 80 to 90 percent of the battery's fully charged state and initiates the absorption stage is the ____.
The second stage of battery charging, where the voltage remains constant, current is gradually reduced as resistance in the circuit increases, and the charging voltage is typically highest, is the ____.
To generate the desired voltage and current capacity, a collection of batteries is electrically connected in parallel and series combinations to form a(n) ____.
A simple form of battery charge controller that short the PV array by charging power to a false load when the charging process is complete but creates heat in the process is the ____.
A special charging cycle used intermittently on flooded batteries to rejuvenate and circulate the electrolyte through gassing by applying higher than normal charge voltages for a specified period of time to create a bubbling activity inside the battery and redistribute the electrolyte is called the ____ stage.
A battery charge controller that opens the charging circuit from the PV array once charging is complete is a(n) ____ controller.