My Crossword Maker Logo
Powered by BrightSprout
Save Status:
or to save your progress. The page will not refresh.
Controls:
SPACEBAR SWITCHES TYPING DIRECTION
Answer Key:
Edit a Copy:
Make Your Own:
Crucigrama Sopa de Letras Hoja de Trabajo
Calificar este Puzzle:
Log in or sign up to rate this puzzle.

Modules 7,8,9 Trade Terms

Horizontales
____ are rigid structures, either suspended or mounted, that are used to support electrical conductors.
____ are steel troughs designed to carry electrical wire and cable.
____ are 90-degree bends made in two or more parallel sections of conduit, where the radius of each ben in conduit after the inside bend is respectively increased.
____ is the length of the bent section of conduit measured from the bottom, centerline, or top of the straight section to the end of the conduit being bent.
When materials meet a regulatory agency's requirements, the material is then said to be ____.
A(n) ____ is the connection of two or more conductors.
A(n) ____ is a large bend that is formed by multiple short bends or shots.
The ____ is the actual length of the conduit that will be bent.
A(n) ____ area is one that can be reached for service or repair.
Two 90-degree bends with a straight section of conduit between them constitute a(n) ____.
A(n) ____ is used to make a continuous grounding path between equipment and the ground.
The rise in a section of conduit at 90-degrees is called a(n) ____.
A(n) ____ is a manually operated device that is used to pull a wire through conduit.
Verticales
A conductor's ____ is the current the conductor can carry continuously without exceeding its temperature rating.
Composed of foam rubber, a(n) ____ fits inside a piece of conduit and is propelled by the compressed air or vacuumed through the conduit run, pulling a line or tape.
During a pull, a cable may be attached to the pulling rope using a(n) ____,
____ are enclosed channels that are used to house wires and cables.
A(n) ____ is a bend made in a piece of conduit to alter it's course.
When something is in a(n) ____, it is not permanently closed in by the structure or finish of a building.
____ is a regulatory agency that evaluates and approves electrical components and equipment.
On a cable puller, the ____ is the part on which the pulling rope is wrapped and pulled.
An intermediate point on a main circuit where another wire is connected to supply electrical current to another circuit is called a(n) ____.
____ is the distance that is saved by the arc of a 90-degree bend.
Similar to pipe, ____ is a round raceway that houses conductors.
Electrical connectors that could be exposed to the environment are housed in a long, narrow box, or a ____.
A(n) ____ is two bends placed in a piece of conduit in order to navigate around obstructions.