My Crossword Maker Logo
Powered by BrightSprout
Save Status:
or to save your progress. The page will not refresh.
Controls:
SPACEBAR SWITCHES TYPING DIRECTION
Answer Key:
Edit a Copy:
Make Your Own:
Crucigrama Sopa de Letras Hoja de Trabajo
Calificar este Puzzle:
Log in or sign up to rate this puzzle.

Module 7 Trade Terms

Horizontales
A(n) ____ should be attached to a truss that is being set by a crane.
A(n) ____ is an L-shaped arrangement of lumber that is fastened to the tops of long ceiling joists to keep them in alignment.
When framing members are assembled one piece at a time, it is referred to as ____.
A roof with four sides extending tward the center is a(n) ____.
The framework extending from the roof surface that provides additional light and ventilation is referred to as a(n) ____.
A ____ roof has two slopes that meet at the center to form a point.
A truss is fastened to a top plate by toenailing through the ____
A(n) ____ is used when lifting large members with a crane.
Verticales
The board nailed to the rafter tails in order to space the rafters is the ____.
A(n) ____ is a 1 x 4 member that is nailed to the ceiling joists to prevent twisting and bowing of the joists.
An overhang is framed using short lengths of boards known as a(n) ____.
The ____ extends beyond the gable and supports a decorative end piece.
Commercial roofs may be supported by ____, which are welded to the structural steel.
The upper ends of rafters are fastened to the ____.
A(n) ____ is a roof support member that runs parallel to the plate and is installed between the plate and the ridgeboard.
The amount of rise per 12" of run is referred to as the ____.
____ are used to fasten framing members to one another.