My Crossword Maker Logo
Powered by BrightSprout
Save Status:
or to save your progress. The page will not refresh.
Controls:
SPACEBAR SWITCHES TYPING DIRECTION
Answer Key:
Edit a Copy:
Make Your Own:
Crucigrama Sopa de Letras Hoja de Trabajo
Calificar este Puzzle:
Log in or sign up to rate this puzzle.

Module 2 Trade Terms

Horizontales
The main ingredient in plaster and gypsum board is ____.
A floor is supported by equally spaced ____.
The horizontal members that support the framework of a building at the bottom of a wall is the ____.
After installing finishing nails, use a(n) ____ to recess the nails, then fill the holes with putty.
____ has hardened and gained its structural strength.
Concrete that is in a semiliquid and moldable state is referred to as ____.
____ are protective natural or synthetic coatings.
____ are materials added to a concrete mix to alter certain properties.
When two square-cut pieces of material are placed end-to-end, it is called a(n) ____.
The ____ describes safe handling methods for a particular substance.
Use ____ nails to prevent rusting.
Verticales
A(n) ____ floor is built out to extend beyond the last point of support.
In ____ siding, each board is tapered and grooved so the upper piece fits tightly over the lower piece.
____ is concrete that is hardened but has not achieved is structural strength.
The chemicals in porland cement react with water through a process know as ____.
A lumber quantity measure equivalent to a board measuring 1" thick, 12" wide, and 1' long is a ____.
A(n) ____ is a popular homebuilding option because the higher ceiling makes the room feel more spacious.
Crown molding is a type of ____.
When applying finish roofing or siding material to a structure, it is fastened to the ____.
The amount of space occupied by a two dimensional object is referred to as ____.
A(n) ____ material is capable of easily igniting and rapidly burning.
To determine the ____, multiply the length, width, and height together.
When mixing epoxy, the ____ is the substance that causes the reaction in the hardener.
When referring to nail length, the letter "d" is an abbreviation for ____.
The roof sheathing is attached to to ____.
____ is the ash produced during the reduction of iron ore to iron in a blast furnace.