My Crossword Maker Logo
Powered by BrightSprout
Save Status:
or to save your progress. The page will not refresh.
Controls:
SPACEBAR SWITCHES TYPING DIRECTION
Answer Key:
Edit a Copy:
Make Your Own:
Crucigrama Sopa de Letras Hoja de Trabajo
Calificar este Puzzle:
Log in or sign up to rate this puzzle.

Module 3 Trade Terms

Horizontales
The installation of crown molding often requires that wood be cut with both a bevel and a miter, which is known as a(n) ____.
When cutting trim molding around a door frame, you would most likely be performing ____.
The ____ should be sharpened on a bench grinder to ensure smooth cutting.
____ are formed when the tongue of a workpiece is fit into a rectangular cutout or opening on an adjoinin piece.
If a long board has an imperfect edge, a jointer plane can be used to make it ____.
A rectangular cut made along the edge or end of a board to receive another board is known as rabbit cuts.
A cut that is made across the sloping edge or side of a workpiece at an angle of less than 90 degrees is known as a(n) ____.
Verticales
A(n) ____ can be used to cut lumber at precise angles.
For a cabinet drawer, ____ should be cut in the sides, from, and back to receive the drawer bottom.
A(n) ____ is a triagular joint often used to attach drawer fronts to the sides in antique furniture.
The installation of a strike plate and hinges in a door jamb would require ____.
A cut made across the grain in lumber known a
One of the hazards associated with a table saw is the possibility of ____ as the stock gets pinched as it travels through the saw blade.
Use a(n) ____ to hold a door safely on edge when planing it.
When measuring, account for the amount of material removed by the saw blade, which is known as the ____.