My Crossword Maker Logo
Powered by BrightSprout
Save Status:
or to save your progress. The page will not refresh.
Controls:
SPACEBAR SWITCHES TYPING DIRECTION
Answer Key:
Edit a Copy:
Make Your Own:
Crucigrama Sopa de Letras Hoja de Trabajo
Calificar este Puzzle:
Log in or sign up to rate this puzzle.

Module 7 Roof Systems 1

  












    
Horizontales
A roof member that does not extend the entire distance from the ridge to the top plate
They prevent opposite walls from spreading apart
upper horizontal framing member of the wall used to carry the roof trusses or rafters
This roof consist of two intersecting gable roofs. The two roofs meet at a valley
When two joist meet they must go by each other a minimum of at least 3"
A roof member that extends diagonally from the outside corner of the top plate to the ridge
Has four sides or slopes extending toward the ridge of the building
Verticales
Also known as a lean-to roof, it has a flat,sloped construction
A roof member that extends from the inside corner of the top plate to the ridge along the lines where two roofs intersect
A structural member that extends from the top plate to the ridge board in a direction perpendicular to the wall plate
Provide support for the joist at the center of a span
Provide more available space in the upper level than a gable roof
This roof consist of two intersecting hip roofs
Has four sloping sides usually on commercial buildings
Highest horizontal roof member
Has two slopes that meet at the main ridge board