What is created if we have excessive liquid line length or lift?
In a low voltage circuit, a corroded wire to terminal connection acts like an additional _________ ?
A wet bulb and dry bulb reading that are very close to each other means that the ___________ is high.
Bent vanes on a direct drive blower motor can cause increased noise, excessive motor wear and what ____________?
The difference between a grille and a register is the register has a ____________?
Typically what is added to ductwork to increase the rigidity and reduce vibration?
The kind of energy that the condenser removes is both sensible and __________ ?
On a dual fuel system heat pump with oil backup, what must be added so both units can't run at the same time?
The continuity of a fuse should be tested with the circuit ___________?
The outdoor fan on a heat pump stops during defrost to __________ defrost times.
What type of leak detector can detect a 0.05 oz. per year loss of refrigerant?
The component used to reduce sound transmission and prevent water leaks on a roof top package unit.
Refrigerant boils in the _________ ?
A voltage reading across a closed contact in a 24V control circuit indicates?
On a service call for a cooling problem with a heat pump, the liquid line has frost/condensation on it, the most likely cause would be the liquid line is _________ .
Verticales
Drive slips/cleats are typically installed on what sides of a rectangular duct?
The total current in a parallel circuit is the ___________ of the individual branch currents.
To properly set a heat anticipator it is necessary to check the heating circuit _________ .
What effect does a low charge have on reversing valve operations?
The best way to balance a system is by _________ pressure.
A bright red or orange glow from the resistance element in a duct heater means the air flow is?
What can cause a lower than normal suction pressure.
Three things that happen when a heat pump enters defrost are, the reversing valve switches, the outdoor fan shuts down, and the _________ energizes?
If the technician believes that a hermetic compressor has a permanently open internal overload protector, the technician should test the compressor while it is ________ ?
When balancing a newly installed zone system, the dampers should be completely __________ ?
When performing preventative maintenance on a heat pump, the technician should check the outdoor fan to be sure that it spins freely with no _________?
A residential supply diffuser that is noisy because of a loose vane is best serviced how?
Cool air complaints can be caused by excessive ___________ velocities.
What is used when brazing to prevent oxidation?
To properly check an energized compressor circuit the technician should use a VOM set for _________ ?
LISTA DE PALABRAS:
Sign Up
Log In
Make a Suggestion
We're always looking for ways to make My Crossword Maker
better and can't wait to hear what suggestions you have :)
Your Email:
Suggestion:
Report an Issue
Quick Answers:
Where is my puzzle?
All your puzzles are accessible from your 'My Puzzles' page, which you can access using the navigation bar at the top when you are logged in.
Be sure to log in using the same email address you used when you created your puzzle.
How do I print?
There is a 'Make Printable' button on the top left of your puzzle that will let you sign up for a plan or purchase a single puzzle.
Once paid, that button will turn into a 'Preview + Publish' button that will put your puzzle in a format that can be printed or solved online.
Once you publish your puzzle, you can click the print icon or use your browser’s print function.
It looks weird when printed.
First make sure you’ve published your puzzle. See the 'How do I print?' section above for more information.
99% of other printing issues have to do with printer settings. Instead of trying to fiddle with printer settings, which can be time-consuming and frustrating, there are a couple workarounds you can try.
You can try printing from a different browser, since different browsers have different default print settings. Alternately, you can try saving as a PDF (next to the print icon) and print that.
Why isn’t this free?
We invested in building a number of premium features that free sites are unable to offer: the ability to automatically or manually add words to your puzzle, save-as-you-go puzzle editing, the ability to access your puzzles from any computer, an uncluttered and ad-free interface, the ability for friends and colleagues to solve your puzzles online, and quick responsiveness to reported issues.
My Crossword Maker is the lowest-price service we've found that provides these features, and is designed for people who are not satisfied with what free sites are able to provide.
I thought this was free.
We’re sorry you thought My Crossword Maker was free, that must have been frustrating.
We’re constantly trying to provide a clear and straightforward user experience, and we’re not trying to hide the price: on the page where you make your puzzle, the price is listed in the overview in the top left (before you log in), below the 'Make Printable' button (after you log in), in the FAQ below the grid, and also in the tour.
Unfortunately, we have limited control over how we show up in Google and on other sites, so if they show My Crossword Maker when someone searches for a free site we can’t do anything about that.
It says there is no account with my email.
First check whether you used a different email address to create your account. Your login email is the email address where you received a welcome email from us.
Alternately, it’s possible there was a typo in your email when you created your account. If so, report an issue below and provide the name and last four digits on the card you used when you signed up. We’ll use this information to track down your account.
I am being asked to pay a second time.
If you are a member of My Crossword Maker and are still being asked for payment, then you may have inadvertently created a second account.
Your paid account will have the email address where you received an email confirming your subscription.
If you never received such an email, or are still unable to find your paid account, report an issue below and provide the name and last four digits on the card you used when you signed up. We’ll use this information to track down your account.
My password reset isn’t working.
For security a human can’t see or reset your password, so read the below information carefully.
If you haven’t gotten the password reset email, check your spam folder, be sure you’re checking the email account that the email was sent to, and be aware that some school email systems block emails from non-school email addresses.
If you have the password reset email but the password isn’t accepted, be sure you are using the most recent password reset email: sometimes people will hit the button twice, and only the second password will work.
Be sure if you copy-paste the password not to get a space on the outside, or if you're typing it keep in mind that it's case-sensitive and that a lower-case L can look like the number 1, etc.
How do I cancel?
You can cancel your subscription from your 'My Account' page, which you can access using the navigation bar at the top when you are logged in.
Support representatives cannot cancel a subscription on your behalf.
Not all my words are in my puzzle.
When you hit the 'Arrange' button, our algorithm will try to arrange all your words on the grid, and will move words around to try to fit the most words.
This will get all the words on the grid about 90% of the time, depending on the word list. For the other 10%, you will get an alert explaining that the words that did not fit were added to the scratchpad.
It prints on two pages.
Big puzzles won’t always print on one page — the clues and grid are the smallest we could make them while keeping them readable for everyone.
That said, different browsers print in slightly different ways, so you could try using 'print preview' using a different browser (or try the PDF button) to see if you like how that looks better.
I didn’t hear back from you.
We generally respond to all reported issues in about a day. If it’s been a few days and you haven’t heard back from us, it’s possible we sent an email that didn’t reach you.
Check your spam folder, and be aware that some school email systems block emails from non-school email addresses. Try providing a different email address if you think our emails to you are being blocked.
Answers take about a day. Try the Quick Answers above for a faster resolution.
Where is my puzzle?