My Crossword Maker Logo
Powered by BrightSprout
Save Status:
or to save your progress. The page will not refresh.
Controls:
SPACEBAR SWITCHES TYPING DIRECTION
Answer Key:
Edit a Copy:
Make Your Own:
Crucigrama Sopa de Letras Hoja de Trabajo
Calificar este Puzzle:
Log in or sign up to rate this puzzle.

Heat Pump and AC Basics

Complete The Crossword Below
Horizontales
The best way to balance a system is by _________ pressure.
The component used to reduce sound transmission and prevent water leaks on a roof top package unit.
What is used when brazing to prevent oxidation?
Can cause a lower than normal suction pressure.
A bright red or orange glow from the resistance element in a duct heater means the air flow is?
If the technician believes that a hermetic compressor has a permanently open internal overload protector, the technician should test the compressor while it is ________ ?
A residential supply diffuser that is noisy because of a loose vane is best serviced how?
The outdoor fan on a heat pump stops during defrost to __________ defrost times.
When balancing a newly installed zone system, the dampers should be completely __________ ?
A wet bulb and dry bulb reading that are very close to each other means that the ___________ is high.
What effect does a low charge have on reversing valve operations?
Refrigerant boils in the _________ ?
Verticales
The kind of energy that the condenser removes is both sensible and __________ ?
On a dual fuel system what must be added so both units don't run at the same time?
On a service call for a cooling problem with a heat pump, the liquid line has condensation on it the most likely cause would be the liquid line is _________ .
What type of leak detector can detect a 0.05 oz. per year loss of refrigerant?
Drive slips/cleats are typically installed on what sides of a rectangular duct?
A voltage reading across a closed contact in a 24V control circuit indicates?
To properly set a heat anticipator it is necessary to check the heating circuit _________ .
In a low voltage circuit, a corroded wire to terminal connection acts like an additional _________ ?
To properly check an energized compressor circuit the technician should use a VOM set for _________ ?