My Crossword Maker Logo
Powered by BrightSprout
Save Status:
or to save your progress. The page will not refresh.
Controls:
SPACEBAR SWITCHES TYPING DIRECTION
Answer Key:
Edit a Copy:
Make Your Own:
Crucigrama Sopa de Letras Hoja de Trabajo
Calificar este Puzzle:
Log in or sign up to rate this puzzle.

Master Cylinders Wheel Cylinders and Calipers

Puzzle Type: Educational
Horizontales
Master cylinder seals should be ________ before installation
Type of brake bleeder that "sucks".
Brake fluid should never be _________.
__________ brake bleeding requires a helper
Check under the wheel cylinder _______ for a leak that is just beginning
The master cylinder changes pedal movement into ________ pressure
Aluminum master cylinder bores have a ______ coating
Master cylinders have 2 of these
Maximum pressure that should be applied to a plastic brake reservoir
Type of brake bleeder that supplies the system with fluid
Valve that is used as a warning device in split brake systems
____________ bleeding a new master cylinder helps remove air from the system when it is replaced
Floating calipers apply force to ______ side(s) of the rotor
Hydraulic pressure forces the wheel cylinder pistons________.
Type of caliper that has 2 or 4 pistons
Wheel cylinder cups should face the ______ of the cylinder
An aluminum master cylinder bore that is scored should be _________.
Type of brake calipers that use a quick take up master cylinder
Part of the master cylinder cover that is vented
Used to retract caliper pistons when replacing brake pads
Modern master cylinder housings are made of ________.
The piston on a single piston caliper will always be located ______ of the brake rotor
______________ have 2 pistons
Verticales
Used to remove air from a brake system
Type of brake system that uses a residual pressure valve
A ___________ bleeder screw will prevent fluid flow.
Procedure of letting a brake system bleed itself
Master cylinder pistons are usually held in place by a ___________.
_______ can be used to remove caliper pistons for service
A small _______ keeps the wheel cylinder cups against the pistons
The bleeder screw will always located at the ______ of the brake component
Limits the hydraulic pressure to the rear wheels
Switch that turns on the brake lights
Port that allows the pressure chamber to be refilled from the reservoir
Type of caliper that uses 1 or 2 pistons.
Excessive wear on one brake shoe would indicate a _______ wheel cylinder piston
Oil in a master cylinder may cause the pistons to _______
Caliper pistons should be reinstalled by ______.
Brake pedal linkage uses ___________ leverage
Pressure valve that keeps a small amount of pressure in the wheel cylinders
____________ piston cup that ensures the piston develops pressure
Brake fluid damages ___________
Aluminum calipers with an anodized coating should not be ________.