My Crossword Maker Logo
Powered by BrightSprout
Save Status:
or to save your progress. The page will not refresh.
Controls:
SPACEBAR SWITCHES TYPING DIRECTION
Answer Key:
Edit a Copy:
Make Your Own:
Crucigrama Sopa de Letras Hoja de Trabajo
Calificar este Puzzle:
Log in or sign up to rate this puzzle.

Intro to PLC - 1

Horizontales
RES instructions are used with ___, CTU, or CDU instructions.
____ cannot overlap.
RES instruction are not used with ___ instructions because unpredictable machine operation can result.
Timer instructions are located in data table file ___.
The placement of programming instructions can be used to minimize ___ scan time.
Low AC voltages ___ are used for doorbells, security systems, and as a voltage level for PLC inputs.
Input devices can be programmed in ____ options.
The most common analog input signal from an input device to a PLC is zero volts DC to ____.
Input and Output addresses are formatted as ____ or slot/bit.
Low ___ requirements in the input section of a PLC is one major advantage of using a PLC over conventional hardwired circuits.
Verticales
___ of the data table files are preconfigured, and the filetype cannot be changed.
Each rung must contain at least ____ output component control instruction.
___ input instructions are true when the address of the instruction contains a 1.
PLC actuators require _____ to power the actuator motor.
____ is a wiring method where the power circuit and the control circuit ae wired point-to-point.
____ is the positive or negative state of an object's connections.
In PLC programming, the advantage of adding ___ is that additional information can also be added that provides even more meaning to the device.
Pushbuttons, selector switches, limit switches, and proximity switches are common ____.
____ cable must be run in a separate conduit from other energized conductors.
PLC operating cycles occur in a matter of _____.